Energizer MMT-511 Guide de l'utilisateur Page 127
- Page / 170
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Troubleshooting & Care 115
If the pump goes to the REWIND screen after you clear the alarm,
you will need to perform a rewind per the instructions in Chapter
2, Getting Started.
What is a check settings alarm?
A CHECK SETTINGS alarm occurs when one of the following
actions occur:
■
pump was reset due to an error and time and date were not
reset,
■
battery has been taken out of the pump and time and date
were not reset,
■
or the clear settings procedure performed and time and date
were not reset.
This alarm will repeat every 10 minutes until you reset the time
and date. Also, make sure that all your settings are correct.
I submerged my pump in water
1. Pat the outside of the case until dry.
2. Open the reservoir compartment and check the compartment
and reservoir for water. If wet, dry it completely within ten (10)
mintues of exposure to water. Exposure to liquids, including
water or insulin can corrode the mechanism.
3. Dry the reservoir completely - do NOT place a wet reservior in
the pump.
4. Do not use hot air to dry your pump. This may damage your
pump’s internal electronics.
5. Check the battery compartment and the battery - if wet, let
them dry completely before using the pump.
- Paradigm™ Infusion Pump 1
- Electrostatic Discharge 3
- Table of Contents 5
- Chapter 5 7
- Chapter 6 7
- Chapter 7 8
- Chapter 8 8
- Chapter 9 9
- Chapter 10 9
- Chapter 11 10
- Chapter 12 11
- Chapter 1 13
- Introduction 13
- Assistance 14
- Availability 14
- Emergency kit 15
- 4 Chapter 1 16
- Your pump 17
- 6 Chapter 1 18
- Introduction 7 19
- Home screen 20
- Modes of operation 20
- Attention 21
- Pump buttons 22
- Introduction 11 23
- Main menu 24
- Bolus menu 25
- Suspend 25
- Basal menu 26
- Prime menu 26
- Utilities menu 26
- Initial pump settings 27
- Basal rate information 28
- Meal boluses 28
- Correction bolus 28
- Blood glucose targets 28
- Chapter 2 29
- Getting Started 29
- Preparing your pump for use 30
- Installing the reservoir 33
- Removing the reservoir 34
- Rewinding the pump 34
- Verifying insulin type 35
- Changing insulin type 36
- Getting Started 25 37
- Disconnect from Body 37
- Insert/Lock Reservoir 37
- Hold ACT to Prime 37
- MANUAL PRIME 38
- Getting Started 27 39
- Manual Prime 40
- Priming with fixed prime 42
- FIXED PRIME 43
- PRIME DELIVERY 43
- Reviewing the prime history 44
- How to wear the pump 45
- 34 Chapter 2 46
- Chapter 3 47
- Status 47
- 36 Chapter 3 48
- Chapter 4 49
- Bolus Menu 49
- BOLUS HISTORY 50
- MAX BOLUS SETUP 50
- SET BOLUS 50
- Delivering a normal bolus 51
- Dual/Square bolus 52
- 42 Chapter 4 54
- Bolus Menu 43 55
- Bolus Menu 45 57
- Dual wave bolus 58
- Bolus Menu 47 59
- Dual Now 59
- Delivering an express bolus 61
- 50 Chapter 4 62
- Normal Bolus 62
- Square Wave Bolus 62
- Dual Wave Bolus 62
- Bolus Menu 51 63
- Setting up easy bolus 65
- 54 Chapter 4 66
- Delivering an easy bolus 67
- Bolus history 68
- 58 Chapter 4 70
- Chapter 5 71
- Basal 71
- Basal 61 73
- Delivering a basal 74
- SET START TIME 2 75
- Basal Rate 2 75
- BASAL RATE 75
- Setting max basal rate 76
- BASAL MENU 77
- How does it work? 78
- STATUS 2:12P U100u 80
- Last Bolus N 3.8U 80
- 9:07A 11 NOV 80
- Basal 1: 0.8 U/H 80
- Personal basal patterns 81
- 70 Chapter 5 82
- Set/Edit Temp Basal 85
- Select Patterns 85
- Basal review 86
- Basal 75 87
- 76 Chapter 5 88
- Press ACT to Stop Pump 89
- Suspending the pump 90
- Resuming pump delivery 91
- 80 Chapter 6 92
- Chapter 7 93
- Utilities 93
- Setting the alert type 94
- Type. Press ACT 95
- Press ACT 95
- Using Auto-off 96
- Reviewing the alarms 97
- Daily totals 98
- Reviewing the daily totals 99
- Setting up block 100
- Utilities 89 101
- UTILITIES MENU 101
- BLOCK OPTION 101
- Setting the time and date 102
- 10:12 PM 103
- 92 Chapter 7 104
- Language 105
- Setting the language 105
- RF options (remote control) 106
- Adding an RF ID 106
- Utilities 95 107
- RF OPTION 107
- RF ID MENU 107
- ADD RF ID 107
- Deleting an RF ID 108
- Utilities 97 109
- DELETE RF ID 109
- Reviewing the RF ID codes 110
- Clear pump 111
- Clearing pump 112
- REWINDING 114
- INSULIN TYPE 114
- Selftest 115
- 104 Chapter 7 116
- MAIN MENU 116
- Utilities 105 117
- 106 Chapter 7 118
- Chapter 8 119
- Remote Control 119
- Using your remote control 120
- Waking up your pump 121
- Deliver an easy bolus 122
- Remote Control 111 123
- Cleaning your remote control 124
- Chapter 9 125
- 114 Chapter 9 126
- I submerged my pump in water 127
- My screen appears distorted 128
- Pump maintenance 129
- 118 Chapter 9 130
- Cleaning your pump 131
- Storing your pump 131
- Precautions 132
- Special circumstances 132
- 122 Chapter 9 134
- Chapter 10 135
- User Safety 135
- Warnings 136
- General precautions 137
- 126 Chapter 10 138
- Precautions - hypoglycemia 139
- Precautions - hyperglycemia 140
- User Safety 129 141
- Adverse reactions 142
- Hypoglycemia 143
- Site infection/abscesses 143
- 132 Chapter 10 144
- User Safety 133 145
- 134 Chapter 10 146
- Chapter 11 147
- Alarms and Alerts 147
- Delivery stopped 150
- Rewind Pump 150
- ESC,ACT to clear 150
- Alarms and Alerts 141 153
- Replace battery now 153
- Use 1 AAA alkaline 153
- Message in Alarm History 154
- Chapter 12 155
- Pump Specifications 155
- 144 Chapter 12 156
- Easy bolus 157
- Infusion pressure 157
- Insulin concentration/type 157
- Normal bolus 157
- Occlusion detection 158
- Power supply 158
- Pump Specifications 147 159
- Square wave bolus 160
- Temporary basal rate 160
- Time and date display 160
- Water tight 160
- Factory default settings 161
- Icon table 162
- Keep dry 163
- 152 Chapter 12 164
- Index 165
© 2020, manymanuals.fr. Tous droits réservés | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels