Energizer MMT-511 Guide de l'utilisateur Page 124

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 170
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 123
112 Chapter 8
2. Make sure the RF ID is correctly entered.
3. Make sure the pump is not in a “Low Batt” condition.
4. Call the 24-hour Product Help-line for assistance.
Cleaning your remote control
Use a damp cloth and mild soap to clean the outside of your remote
control. Do not use bleach or ammonia.
1. Never use organic solvents, such as nail polish remover or paint
thinner, to clean your remote control.
If the remote control is dropped
1. Make sure that the remote control panels (front and rear) are
still attached.
2. Press and hold the ACT button on the remote control to check
communication with the pump.
If the remote control falls in water
1. Pat the outside of the case with a cloth until dry.
2. Following the battery installation procedure, unsnap the rear
panel, and allow the two sections to dry out. Do not use hot air
to dry your remote control as this may damage internal elec-
tronics.
3. Call the 24-hour Product Help-line for assistance.
Vue de la page 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 169 170

Commentaires sur ces manuels

Pas de commentaire